ED 2.6 charger

94 12valve

94 12valve

Kingpin
Joined
Nov 3, 2007
Messages
2,002
I'm selling the turbo I ran all last year on my puller it meets NADM 2.6 class rules. It ran very well on my stock piston/ stock valve motor, the only reason I'm selling this charger is to go a little bigger for this year. The charger is at ED now, there going through it to make sure everything is good before I sell it.

Specs on the charger are

2.630" inducer bore
68mm inducer
99mm exducer

74/83 turbine
1.25 housing T4

If the buyer would like a different housing It can be changed. I'll pay for the housing swap, so the price I'm asking will include what ever housing you would like. I'm asking $1100 + shipping ( will be shipped direct from ED).

http://www.youtube.com/watch?v=AhZNmGlLBZU
 
I watched your pulling videos. I'm impressed. What mods do you have? I'm gonna pull 2.6 this year.

Jordan
 
20447_278032216166_557766166_3922993_7089973_n.jpg
 
So did you figure out what was the hold up with your setup? Did you get it to fuel past 2800? Laser cuts or 191's? Other than the turbo lag part, did you like the high timing(30*) on the street?


Jordan
 
mopar or no car said:
So did you figure out what was the hold up with your setup? Did you get it to fuel past 2800? Laser cuts or 191's? Other than the turbo lag part, did you like the high timing(30*) on the street?


Jordan
Click to expand...

yes, I figured out the problem it was the throttle cable. In all the pulling videos that was with 191's. 30* on the street was not the best idea I liked 22* much better but 30* is what I was pulling with.

Dave
 
cant wait for you to get that 4.1 charger to run in the new unlimited class LOL
Good luck with your sale:Cheer:
 
You must log in or register to reply here.
Back
Top