Edge Juice and FASS...Whos got em?

daysel

daysel

....
Joined
Oct 29, 2007
Messages
82
Im looking for a fitting that goes from the FASS fuel line to the IP that will allow the Edge Juice(fp) sensor with it.
Or does someone have pics of their set up or a suggestion?
 
I'll have to remove the line/sensor because I don't remember how it is exactly or what I need...unless someone here does.:poke:
 
my edge came with a bandjo fitting that went into the injection pump for the fuel pressure and i have a fass
 
I had a FASS with juice, all you do is go to lowes and get a 3/8" tee, two 3/8" barbed ends with 3/8" male end, and a 3/8" X 1/8" reducer. It wont disturb the flow any and gives an accurate reading. just place the tee about 4" form the pump.
 
Get two 3/8 barb to -6an female fittings and one -6an male to male fuel pressure fitting (will have an 1/8" NPT port in it).

Cut your fass line anywhere you see fit, insert a barb to -6 fitting in each cut end of the hose and insert the new fitting. Now you have a port and trully undisturbed flow.
 
What size fitting goes into the injection pump? I have the tee with the sensor ready to go but, I can't find anything to go into the IP at Lowes or Home depot.
Whatever extra fittings came with the edge are long gone.
All I need is an elbow going into the IP with a barbed end on the other side for the fuel line.
Nothing else is open today.:bang
Thanks for the help.
 
daysel said:
What size fitting goes into the injection pump? I have the tee with the sensor ready to go but, I can't find anything to go into the IP at Lowes or Home depot.
Whatever extra fittings came with the edge are long gone.
All I need is an elbow going into the IP with a barbed end on the other side for the fuel line.
Nothing else is open today.:bang
Thanks for the help.
Click to expand...

WELL.....for anyone that wants to know:

P-7100 Pump: M14x1.5

CP3, VP44, and pretty much any other banjo bolt: M12x1.5
 
You must log in or register to reply here.
Back
Top