Extrude hone 12V injectors

[9 LIVES]

I've got a set of extrude hone 12V injectors that may have 100 miles on them since they were done.

I had them done 4/24/09 didn't install them till June when the new motor was built. $549.05 when done by Kennametal extrude hone in Irwin PA

I had them pop checked & cleaned on 10/2/09 for $84.00

They were extrude honed out to Garmon 5.0 specs.

Receipts in pictures below. Open to offers please do not low ball. I've got $713.00 into these including buying these from a Comp D members.

 

[9 LIVES]

Offers are welcome!
They burn 10X cleaner than EDM injectors.

 

[cumminslow]

i was told that they dont last as long edm is it true ?

 

[D Gandy]

What size are these nozzles? Not familiar with the Garmon 5.0 specs.

 

[9 LIVES]

i was told that they dont last as long edm is it true ?

That's news to me

Diesel Fuel Nozzles - Extrude Hone Powerflow

there is some good info on that site.

 

[9 LIVES]

What size are these nozzles? Not familiar with the Garmon 5.0 specs.

I've been told they are in the range of 5X.014-5X.016 I think they are measured more by flow than actual hole size. 50% more fuel than a stock injector. Its what's in his pro street race truck

 

[bignastydodge]

injectors

hey i was wondering if u recieved the injectors an money yet. your pm box is full.

 

[bignastydodge]

injectors

hey i was wondering if u ever sent them off an ur pm box is full again.

 

[Rich Buckley]

will they make my stock 12v 3500 smoke?

 

[9 LIVES]

Quite possibleLOL