ComnRailPwr
New member
- Joined
- Jun 15, 2009
- Messages
- 3,293
Don's F1 Flux 3 Hellfire 150 HP nozzles for an 03-04 HPCR (non 600-610 series motor). have about 2000 miles and 8 hooks on them. bought bigger/different nozzles so i do not need these anymore. always ran with fleetguard 2 micron filtration and dual water separator's for protection! perfect condition and awesome power. were $1200 new a couple months ago. will sell for
$700 shipped to lower 48
From Don's site:
For the 03-04 the Flux spraying holes are formed on a new, blank nozzle with the most accurate microscope directed EDM machining available. All parameters of fuel flow rate, parallelism, spray angle agreement and spray hole size are exact. Our fuel flow rates are the most accurate to real world conditions than any. This gives smooth idle, even power to each cylinder and and even piston crown temperatures. The 03-04 Flux nozzles are not a "stock" or OEM part from Bosch, Lucas, etc. They are custom built for us by world class manufacturing facilities with 100% of the finish labor and final testing done in-house. None of our parts are sourced from third world countries.
$700 shipped to lower 48
From Don's site:
For the 03-04 the Flux spraying holes are formed on a new, blank nozzle with the most accurate microscope directed EDM machining available. All parameters of fuel flow rate, parallelism, spray angle agreement and spray hole size are exact. Our fuel flow rates are the most accurate to real world conditions than any. This gives smooth idle, even power to each cylinder and and even piston crown temperatures. The 03-04 Flux nozzles are not a "stock" or OEM part from Bosch, Lucas, etc. They are custom built for us by world class manufacturing facilities with 100% of the finish labor and final testing done in-house. None of our parts are sourced from third world countries.
