Fuel Pressure with Edge and FASS

Smokinrebel

Smokinrebel

New member
Joined
May 22, 2008
Messages
4,141
I just installed my first FASS system on a truck. Its my buddies '02 24V. He has Edge juice with attitude, and before we put the FASS on his edge was reading fuel pressure with a sensor that screws into the VP. Well we had to take that out to run the feed line into the VP from the FASS. Just curious how you guys are hooking up the FP sensor up for these trucks with FASS and attitude.

Thanks
Brian
 
Get a 3/8" barbed t-fitting that has whatever thread size the fuel pressure sender is tapped in to it. I also recommend installing a needle valve to help dampen the pulses on the sender or it will knock it out quick.
 
alright i will let him know that. Also, one other idea that i had been approached with was running it back to the pump...since there are places to tap into the pump to read pressure
 
You can do that but then you gotta run all that extra wire and what not. Just splice the line up by the VP and go from there. Makes it simple.
 
You want to see actual pressure supplied to the pump post filter, that way if you start to loose pressure due to a clogged filter you can see it.
 
Thanks guys a i appreciate the help!! Looks like i got an idea of how to take care of problem!
 
http://www.jegs.com/p/Mr.+Gasket/746566/10002/-1

OR get one of these.....

7202975.jpg
 
buddy ordered the valcan T the other day. I will post results. Thanks for your helps guys!
 
You must log in or register to reply here.
Back
Top