Garrett Twin Turbo Set

[Goinbyyabig]

I'm just about ready to install my new turbo setup, so it's time for them to go. They are still on the truck, everything works perfectly, no issues at all, I'm just going bigger. Everything was purchased new, and have been on the truck about 4 years, and about 25,000 miles. The truck makes about 900 HP and 1600 FT. Lbs. on most any chassis dyno with these, and I'm starting to run out of air. Every single piece will be included if I can sell the set all together, so no chasing parts or anything, no fab, etc. Turbos are on my 06 CR.

GT3788R .89 divided T3
GT4508R 1.28 open T4
ATS T# second gen 3 piece manifold
ED 50mm external gate and spacer/tube setup
304 stainless hot pipe, gate dumps into it at a nice angle, wrapped
304 stainless cold pipe
3" stainless cold pipe to I/C
6" aluminum air intake and Amsoil filter
All v-bands on the hot side, T4 at the 80 inlet
5" downpipe included
80mm turbo mounting bracket / drain
Pressure test ports in hot and cold side welded in
All silicone hoses and T-Bolt clamps needed
All water and oil feed/drain lines and hoses included, braided stainless A/N fittings

I am thinking 3500 is a good place to start, as the 80 alone costs about 2500.

Next post will be as soon as I figure out how to post some photos. I can be reached at (518) 3three2 47eight3 call or text.

 

[Goinbyyabig]

 

[Goinbyyabig]

 

[Goinbyyabig]

 

[Goinbyyabig]

 

[Goinbyyabig]

 

[Goinbyyabig]

 

[Goinbyyabig]

 

[Goinbyyabig]

Sold, thanks Travis and CF.