Govenor Springs And 215 Pump

odieub

Member
Joined
Nov 6, 2007
Messages
923
Ok Finally Got My Little 215 12v Put Together And I Installed Some Supose To Be 4k Gsk They Were Dtt And I Was Told They Would Fuel To About 3800 Ok Fine. I Installed And Truck Would Run Fine And Rev To 4k Too But Would Fuel To About 3700 Or 3800. When I Hooked A Traller To It To Go Get A Load As The Rpms Came Up You Talking About Junk. Buck Jump So Bad At About 2300 Or So You Would Have To Just Let Plum Off The Throttle. (the 4k Kit Was Only 2 Springs Per Side? Too) So I Thought Id Just Order Some 3k Just Installed And Same Thing Will Free Rev To 3900 Have Not Pulled A Load Yet Hoe It Is Better But Just Sitting There Running They Are Acting Just Like The Others Ny One Have Any Ideas About Why They Act So Different In The 215 Pump. As The Few 175 Pumps Ive Installed 3k's In Have Been Nothing Like This.
 
Measured With A Dial Caliper From Nut To The End Of Stud It Was About .045 Installed The Same Way. But All The 175 Pumps I Have Ever Done Were Around .060 Like All The Directions I Have Seen.
 
Back
Top