Hard to start.

[JohhnyFoxtrot]

Since I got my injectors back from Don I still seem to be having a hard time starting the truck like I did before I sent them to him. Have white smoke and it runs kind of rough. Once it starts I can shut it off and then wait a while and it will start alot easier and no whit smoke. It seems as if fuel is bleeding off after it sits for a few hours. It doesn't matter if the block is warm on its first start or not still hard to start with white smoke. Is there anything that can bleed off since these bodies were just fixed less than 1000 miles ago?
Here's a video I shot last night after truck had sit in garage overnight. It was in the 30's in there.

http://www.youtube.com/watch?v=u-sjNg99g28

 

[HIGH TECH RAM]

I think its a combination of decompression, no grid heater,No fuel heater cold weather. Your connector tubes might be a tad loose. You can also check the return rate of your injectors. I forget what rate is to high but I'm sure others know the numbers. My 06 started very similar when it was cold but the haze went away. Put your boost fooler on to eliminate them codes!