head studs..now a bubble

[Wozxxx86]

did head studs over the weekend.now i can hear a knock very very slight but still there, and see a very small bubbling between the injector and hold down on #3. tightin it down? or what..? still gotta do the re torque in 2 days so i was gonna look into any issues then

 

[OrangeNV]

Wont hurt to tighten it down

Did you adjust the valves? i would check them

 

[Wozxxx86]

yup i did adjust the valves. im gonna check everything over tomorrow when i retorque. i was just wonderin if anything bad could be to blame. because everything looked 100% upon inspection with the head off.

 

[Ridemywideglide]

If you have a bubbling between the hold down and injector, the only place it can come from is the washer on the other end of the injector. Torque may help, otherwise pull it again and sand or change the washer. Make sure there's not some little piece of gunk down there in the hole that's stopping the seal.

 

[Wozxxx86]

thats what i was figuring..just maybe hadnt noticed it before. always nice to get opinions tho