HMR S4 with downpipe,adaptor,and elbow.

cumminsram

cumminsram

giddy
Joined
Jun 26, 2007
Messages
1,012
Charger is a s400 based charger with a custom front cover with a custom bushing set up to 2.8 from 76mm wheel. It is a t4 foot and a 1.1 exhaust housing. Comes with t3-t4 adaotor thats from Haisleys and comes with hx 40 downpipe also from Haisleys. Setup also comes with stock cast boost elbow. This charger uses stock cast elbow same as holset series so it makes it very nice. Original cost for everything was 2400.00 Has ten hooks from last season and has been sitting in my house since. Dont need it new motor got new charger.



I NEED 1000 for the entire setup and id like it gone before scheid.Located in Northern Indiana.
 
For those asking the turbine wheel seems to be 84mm,but may not be exact im not awesome with precise measurements.

Also may trade towards cummins parts truck,rolling chassis?
 
You must log in or register to reply here.
Back
Top