HTT 62mm compressor wheel and housing

BgBlDodge

BgBlDodge

Hates hippies
Joined
May 7, 2007
Messages
16,647
Got the compressor wheel and housing sitting around my garage from when I converted my HTT 62 in to a 66. Housing is unpolished and they both have about 50k miles on them. $140 shipped for the pair.
 
Still got these. The housing is for a 2nd gen. I will not seperate the two. Price already includes shipping to the lower 48 states.
 
is swapping a out the 64mm wheel and housing to the 62mm that you have something that can be done at home easily or no?
 
you can swap it out at home, but to avoid risk of grenading the turbo you should have it rebalanced. I've seen guys do without rebalancing but at WOT your spinning 90-110K RPM and It's ugly when you spin an out of balance shaft that fast!

Lavon
 
I was told by HTT and the shop that did the 66 swap on mine that the compressor wheels are balanced independently of the shaft and exhaust wheel which are balanced together so yes, you can swap it and most likely be just fine. BUT, I HIGHLY recommend having a shop balance it out for you just to be safe.
 
You must log in or register to reply here.
Back
Top