hx40/htb3 twins

[Diesel Dummy]

Bought these a week ago from another member here(turbolvr) here is what he posted about them......set-up for 2nd gen. includes HX40, HT3B, hotpipe, coldpipe, intake pipe, 5-4" down pipe, bottom oil feed line, and both oil drains (not block fitting), I/C pipe, all clamps and hoses that are needed to install. used but a nice kit, not rusted junk. $1800 obo.

Same offer still stands

put them in not what im looking for at this time
very well built set up.
everything works good fresh hx40, hardly no shaft play on the HTB3.

PM me or call me 607-745-9140 chad

 

[LAmiller]

what's not to like about a that set up?

 

[Diesel Dummy]

needs more polishing to get to what i am looking for right now, i just dont have the time to do it, i do more daily driveing than pulling or racing, its just not what im looking for right now. DD

Hey Lavon hows you been doing! DD

 

[SuperDave4x4]

What do you mean by polishing?

 

[Mike G]

Are you talking about the turbo housings? I just had my manifold, turbo hausings and hotpipe ceramic coated and it came out looking very nice. Ceramic coating will keep the heat in the housings not allowing it to saturate the iron, that will allow for a lower outside temp that wont destroy paint. BTW mine were all rusty when I purchased them second hand aswell. I think with out a good quality coating, your gonna have rust.

 

[B18B1LS1]

Wanna trade for a 66mm single :bigsmile:

 

[02 dodge4x4 5.9]

gimme a call few questions i have 251 294 2548 ben.

 

[SuperDave4x4]

OK. I saw your post about how you didn't want to tune them.

 

[Diesel Dummy]

SOLD!!!!!!

Thanks Adam.



DD