industrial injection 150's

M

Mofugra

New member
Joined
Oct 25, 2009
Messages
45
Anyone have any experience with these in a p-pumped truck? I can get a really good deal on a set up here and then wanted to send them off to get reset.
Also any Albertan's out there know if there's a local shop that would reset them? If not who should they get sent to?
Thanks!!!
 
GCL might do it. I'd just run them at stock VP pressures. My current set is at VP pop's, and they run better than the 150's at p-pump pressures.
 
Tate said:
GCL might do it. I'd just run them at stock VP pressures. My current set is at VP pop's, and they run better than the 150's at p-pump pressures.
Click to expand...

What kind of injectors? II?
I can get a good deal as well on some II 150's, their "dragon flows", but I am hesitant of the ten hole design. I have heard of them breaking tips easily. Any experience?
 
Both of my sets are DDP's. 150's were 7 hole, the 250's are 8 hole. No experience with II other than their 62mm turbo.
 
You must log in or register to reply here.
Back
Top