Injector problem

[Gibson]

Just out brand new from Industrial, 85% cp3, reman 100hp injectors, T&C extreme rail, new cross over tubes and VC gasket. Cranked up fine and ran for 20 mins and then started to have a slight fuel knock. **** it off and was real slow to crank but it ran for another ten mins then started knockin hard and white smokin and billowing white smoke with any added throttle. Wouldn't rev past 1800. No will not crank up but turns over fine. 4,500-5,000 rail pressure when crankin over. No throttle position reading. And #1 cylender misfire. Any ideas?

 

[SMOKED]

drove my truck there three times, pushed it out three times too!!! seems there stuff is hit and miss.

 

[SuperiorRam]

Cp3 timing

 

[Dtruck1]

How do you time the CP3? It is just a three piston pump that supplies pressure to the rail.

 

[AH64ID]

Cp3 timing

No timing required on a CP3.