injector tubes

T

tedbuido

kwitchurbichin
Joined
Jun 7, 2008
Messages
145
anyone know of any larger injector connector tubes for common rails out there ?
 
I believe you can just drill out the edge filters and have the same effect as buying bigger ones.
 
i'm guessing this isn't something they have listed on thier sites ? i've looked around and really didn't see anything on them :poke:
 
don't want to discourage sales but, they don't make any difference. In looking for the rattle my truck has, I removed the extruded tubes I had in my truck and replaced them with new stockers. Didn't make a bit of difference in performance or anything else.
 
Im pretty sure the 6.7 tubes wont work. The lines are different and the angle on the end of the tubes are different.
 
They will work I guess since I have used them before...

Has the same size nut on the lines at the tubes, there is no angle to the tubes either. Only thing different on the outside is the detent is not wto little balls its one long detent.

Have no idea if it made any differance at all.
 
They will work. The ends are exactly the same as the 5.9L. As for difference, i think there are some other issues instead of the cross-over tubes.
 
You'll have no trouble feeding those 90hp injectors and a 66, with the stock tubes. For that matter a stock set of tubes flow enough to mush out stock rods.

IMO I'd keep the edge filters, cp3's are famous for puking small pieces of metal, might help save the injectors.
 
You must log in or register to reply here.
Back
Top