Injectors, Carriers, and Others Parts

RockinRam96

RockinRam96

Active member
Joined
Sep 15, 2011
Messages
2,702
I have been collecting parts to build my work stock puller a little bit tougher. I have since bought a 73 Kenworth for pulling and I'm most certain that these ISB parts wont work to well in a NTC. So this is what I have for sale.

150 HP VP Injectors - $500
I bought these used from a member on CompD. Had them cleaned up by Seth at DPE with new o-rings and compression washers. Set to VP pop off pressure. Ready to go.


Detroit Dana 80 True Trac - $500
For Dana 80 3.73 and numerically lower gear ratios. Only has about 5,000 miles on it and a year in a season in a work stock puller.

Welded Dana 60 Carrier - $200
Stock Dana 60 carrier welded together

HX40 Style 4" Down Pipe - $125
I think this is just aluminized, can't remember if it is stainless or not. Comes with v-band clamp. Never installed, brand new.

T3 to T4 Exhaust Flange Adapter - $50
This is also brand new never installed. Comes with all the hardware and gaskets needed.

HX35 Style 4" Down Pipe - $75
Had this ceramic coated. This has been installed and used.

Connecting Rod Bearings - $25
Standard Size

Main Bearings - $75
Standard Size

Oil Pump - $75
Stock


98-02 Overhead Console - $25
Electronics all work but missing the sunglasses holder and the lights do not work

All prices are "or-best-offer," so make reasonable offers on this stuff guys. Buyer pays shipping.

You can reach me at (585)797-5985. You can call me after 5 pm and text me when ever.

Thanks for looking guys,
Zach
 
Why does the TrueTrac look different than others I've seen? I'm interested, but want to make sure it's all there.
 
The one pic of the carrier from the side is a welded D60 carries. The other pic looking from the top at the ring bolt holes is the true trac.

My bad, I'll get better pics of it tomorrow
 
Sorry fur such a delay. Been super busy the past week. Here is a better pic of the true trac.
ImageUploadedByTapatalk1364947137.258730.jpg
ImageUploadedByTapatalk1364947160.661664.jpg
 
Reasonable offers guys. The new stuff I can't move much on. I think I have reasonable prices listed on them as they are for brand new.

The injectors and carriers I have room to move.
 
Any more info on the sticks?

Sent from my SCH-I535 using Tapatalk 2
 
That's all I have. Like I said I bought them used from a member here, he wasn't sure if a builder. I had them sent to Seth at DPE, cleaned and pop off pressure reset to VP pressure. No run time on them since I've got them back.
 
May be interested in the main and rod bearings. Lemme see how the paycheck looks and ill get back to you
 
You must log in or register to reply here.
Back
Top