Injectors too big?

P

Project Cummins

New member
Joined
Feb 15, 2011
Messages
4
Are 7x.012 with .010 lift too big to run on my truck? I am in the process of doing a p pump swap. it's a 180 hp pump that hasn't been bench tested yet. I'm going to be putting a ht3b turbo under my he351cw for some more Cfm. Is this enough air to clean up all that fuel?
 
They will be smoky but they will make power. Be sure to port the wastegate on that 351.
 
Depending on how you drive it will not be too bad. I had 7x12's in mine with a 66 and 72mm single turbo, and could control the smoke with plate and afc adjustments.
 
2000_fummins said:
Could you explain a little more about porting a wastgate? What uou have to do, an the benifits?
Click to expand...

Basically you bore the WG hole out as larges as you think is feasible to still maintain a seal when the puck is closed. Search the 3rd gen section for info on using the stock turbo in a twin setup.
 
Sweet yeah I have already bored the waste gate out to 1" I hope it's a good setup I already have the injectors and the ht3b so I figure I might as well use them. My only problem is the 3b has a 32cm exhaust housing I don't know if that's goin tO be too big.
 
Alright now I'm on the search for a 26cm housing if anyone has one let me know. What is a twins setup like this capable of if all the supporting mods are there to push them hard?
 
Last edited:
Project Cummins said:
Alright now I'm on the search for a 26cm housing if anyone has one let me know. What is a twins setup like this capable of if all the supporting mods are there to push them hard?
Click to expand...
I have a whole new 3b I'll sell ya cheap with a 26cm housing
 
You must log in or register to reply here.
Back
Top