INJs turbo gears etc

R

Rods

Turbo Crasher
Joined
Apr 23, 2006
Messages
1,972
set of 6x16s i made 651hp with these they work great 500$ , billet 2.6 holset 500$ ,set of dana 60\80 4.10s 300$ , stock i/c 2nd gen 100$
 
Wish I had $800, I would take the injectors and gears.

On the side note that I can sell my 7x12's, who's injectors are they? Anything special done to them?
 
Hey Rodney I tried to text you, can I get the specs on the charger
 
inj are j/l built to my specs they have been narrowed a few degres and some lift mods , turbo is 2.6 intake turbine wheel 2.8 (mm 66\71 ) turbine uses a 4in dp, flange is t4 but the adaptor go es with it , compressor housing uses a 3in slip fit, that 651 was done with this turbo also
 
So the injectors would have the right spray angle for the HO pistons that came in my 02 that are narrower than the SO pistons?
 
should b fine, i run over 30 deg of timing with these and they dont haze at idle if they do its barly and thats when its cold ,, im on my phone my puter is down so emails and such im slow on replys u can text or call 2706220219
 
rods how streetable is the turbo?? im guessing with the right injectors it wouldnt be that bad if it's a 66/71. whats the exhaust side size? have any pictures? what kind of condition is it in? come with everything to install? guessing its an s300 based turbo? Sorry for so many questions, but i'm highly interested in it
 
if u mean pop no, i will set them to yr prefrence btw 300$ shipped on the gears
 
Bump for ya. You got me thinkin on the inj. been trying to move mine. Good luck.
 
You must log in or register to reply here.
Back
Top