Installing Power Windows & Door Locks

[liteweight]

--------------------------------------------------------------------------------

I'm wanting to install power windows & door locks in my 96 standard cab from an auto wrecker.
1- First, how much is involved in the under dash wiring? Do you have to pull or loosen the dash or heater box??
2- Is it plug & play replacing the existing standard door harness?
3- Are all years, 94-02 compatable???
4- Are all cab doors compatable to my standard cab?? I'm keeping my doors just wondering bout window tracks etc.??

Any & all input would be appreciated, as I'm sure this has been done before

thanx in advance

liteweight

 

[BtsNhoS]

shouldnt be to hard of a job its pretty straightforward, 12valves dont have alot of wires in a way haha, but not sure about the door setup that might be a real PITA

 

[RamDave]

It's a plug and play swap. You only need the door harness. It will plug right in under the dash.

 

[Ol' Blue]

I would keep the manual locks lmao my opinion

 

[DRAM2500]

i also am planning on doing a power door swap it has power windows and locks i found the plugs under the dash and have a good ground the fuses in the box are good but i can't seem to get the windows,mirrors,or locks to work i was wondering if anyone else had information on this topic?