Is This A Good Set Up?

O

onesmokingoat

New member
Joined
Feb 23, 2010
Messages
2
I just bought this 01' 2500. It has an Edge Juice w/ Attitude with the Hot unlocked, 150s, an Industrial Injection Silver Bullet 66/74/14 turbo, Airdog 100, Southbend dual disk clutch rated for 650hp, cold air induction, and 5 inch exhaust. Is this a good set up for this truck? And do i need to have any concerns?
 
Sounds like like a pretty solid setup, have head studs been installed? That may be something to look into if not.
 
No i dont think the studs have been changed. But the manifold doesn't look like its been real hot or nothin.
 
Throw a set of 200hp injectors in it and some studs and go have some fun.
 
I agree, not too bad of a set-up, but you have alittle more charger than needed with the 150's... Though, you throw a set of Mach 5-6's in there and it would be better. You definitely need headstuds though.
 
i'd agree on the bigger injectors. i ran 200s with a silver 62, and they were a perfect match. i'd say mach 7s or ddp comps with a silver bullet. JMO
 
I noticed you didnt say anything bout lift pump. Is there an aftermarket one on there already?
 
yea id throw a set of 250s in intead of the 150s that charger will move plenty of air to support the fuel. Headstuds will depends on how much boost your pushing depending where your wastegaste is set at
 
You must log in or register to reply here.
Back
Top