inline6359
Microwaving cats since 01
- Joined
- Aug 28, 2006
- Messages
- 2,043
I plan on dynoing this sat(21st) on a dyno jet about 50 miles from my house. My goal is to break 400hp. I havent set up my sig yet but i will give it to you.
titanitum keepers and hardened retainers
60lb valve springs
4kgsk
0 plate full forward
pre boost screw all the way in
medium tension spring in the afc
star wheel full forward
5in straight exhaust
400 hp SBC clutch
ATS AK5/AK2 twins
SW gauges, 2 boost, pyro and fuel pressure
50psi at idle and 30 psi at WOT fuel pressure
that is everything, i have not left out one thing. Timing is not done yet. During winter i will set timing to 18-19, large fuel lines, and the mack plug, then i will fine tune my pump.
My question is: will i break 400hp as is, (i hope so) and if not what can i do to get a little more fuel before i go? I was thinking of doing the washer mod but i dont want to have the issue discussed(falling out of the keeper), but if it is safe and all i can do for now i will do it. Basically i am looking for 400 right now and will tune so i can get it. any tips are welcomed.
Thanks Rick
titanitum keepers and hardened retainers
60lb valve springs
4kgsk
0 plate full forward
pre boost screw all the way in
medium tension spring in the afc
star wheel full forward
5in straight exhaust
400 hp SBC clutch
ATS AK5/AK2 twins
SW gauges, 2 boost, pyro and fuel pressure
50psi at idle and 30 psi at WOT fuel pressure
that is everything, i have not left out one thing. Timing is not done yet. During winter i will set timing to 18-19, large fuel lines, and the mack plug, then i will fine tune my pump.
My question is: will i break 400hp as is, (i hope so) and if not what can i do to get a little more fuel before i go? I was thinking of doing the washer mod but i dont want to have the issue discussed(falling out of the keeper), but if it is safe and all i can do for now i will do it. Basically i am looking for 400 right now and will tune so i can get it. any tips are welcomed.
Thanks Rick