Large single turbos

Status
Not open for further replies.
S

Smokin 12

New member
Joined
Aug 1, 2012
Messages
16
Looking to run a large single turbo on my truck in sig. Looking to make 800+(more is better) on fuel. Mainly a dd/street truck and occasionally going to pull it. Have been told to look into S475 turbos. Any thoughts, suggestions, experience on what kind of turbo along with compressor wheel sizes (if different than a 75),turbine wheel sizes and exhaust housing sizes. Also should it be gated or not? Going to run spray as well. Not concerned with a little lag. No twins. Thanx
 
anybody read his sig? he is throwing a lot of fuel at that 64 if its all accurate! ha holy crap.

Hit up Taylor Manning, TMONEY on here
 
With the amount of fuel that I have, would it be sufficient for a s475 or not? If not what injector would you all recommend?
 
15 to one compression and you want a big single? If its going to be a street truck good luck.
 
But I'll bite the best bang for the buck seems to be a li s478 with an 87mm turbine and a 1.00 housing.
 
Anyway.... I like the sig Cliff. It's even more distracting than the last.
 
Status
Not open for further replies.
Back
Top