LAST CALL 2003 Cummins block crank & head!

[Mark Nixon]

2003 5.9 block, needs bored at LEAST .020 over, $175.

2003 5.9 HEAD, got wet, needs machined to clean it up, was on a light burn job, $125.

2003 5.9 crank, freshly machined to .010-.010, $150.

IN THE SCRAP BIN RIGHT NOW (I can be persuaded to save them) are the following:

2000 53 block, no cracks, no signs that it will, needs a sleeve to stay standard, $50.

Several 6.7 cams and a 5.9 CR cam and a couple of 2001-2002 cams with tone ring. Make Offer? plus shipping.

1997 BRAZIL 12 valve block with ZERO issues, just needs a hone AT WORSE, $125.

THIS IS THE VERY LAST CHANCE FOR THESE ITEMS, THE SCRAP TRAILER IS STANDING BY!!!

Reply, PM or Call 402-780-5127.

 

[TURBOLVR]

I would take the block/head if you were a few hundred miles closer!

 

[Mark Nixon]

Where are you at?
I'm still needing to get over to east Tennessee to pick up a dead one.

Mark.

 

[TURBOLVR]

I'm in Clarkrange, TN. If you're headed this way, I'm in.

 

[Mark Nixon]

Damn, I'd pass within 15 miles of you, if I come across from Arkansas like I'm planning.

Mark.

 

[TURBOLVR]

Well let me in on the plan and we can get this done.

 

[Mark Nixon]

I'm scrapping riff raff right now, to try to beat the growing grass before it's too late. LOL
I was supposed to start towards Tennesee this weekend to see roachie, but things haven't panned out financially at this point.

The short story is I am hoping I'll be leaving the 1st of the week.
WHEN I go, I'll be pulling the 35 footer most of the way EMPTY, because I also have a bed to retrieve in Arkansas.

Mark.

 

[onesick5.9]

Still have block and head? I'm in north platte

 

[TURBOLVR]

Still have block and head? I'm in north platte

:umno: I should be receiving it Wednesday.

 

[Mark Nixon]

Sorry!
I meant to post that the block and the head is sold.

With any luck I'll see TURBOLVR on Wednesday, if not sooner.

Mark.

 

[TURBOLVR]

Thanks man, lookin forward to it!

 

[Mark Nixon]

The scrap has been moved!
All that's left is the 12 valve block (have the pistons and rods, too) and the CR .010-.010 crank and a couple of cams that I'd forgotten to toss in.

Might also have some oddball miscellaneous stuff.

Mark.

 

[TURBOLVR]

All that's left is the 12 valve block

Mark.

I'll take that too. :Cheer: