lowering compression ratio on pistons

[smokin02dually]

I am building a dedicated 2.6 puller. I am needing advice on how to lower compression. The piston are stock 24 v so pistons I am taking the flycuts 120 thousands deep. How much should I open up the bowl up to get down to around 13.5 to 1 ratio. Thanks for any info

 

[Tony R]

I wouldn't give up compression on a 2.6 motor.

 

[SHughes]

Shave the pistons instead of doing flycuts, should be cheaper too.

 

[ecc_33]

I wouldn't give up compression on a 2.6 motor.

X2 Its a :badidea: to cut much if any in a 2.6 class. With that low of compression you will be hard pressed to stay on top of a good/big 2.6 charger

 

[SledPuller21]

X2 Its a :badidea: to cut much if any in a 2.6 class. With that low of compression you will be hard pressed to stay on top of a good/big 2.6 charger

Your better makes some calls before you stick with that...some of the top 2.6 trucks in the country are around 13.5:1. But for the average build id agree

 

[smokin02dually]

I would consider my motor build to be a little more on the extreme side, 13 mm ag pump, fully ported head, individual runner intake, custom injectors setup for my build hx82 turbo with protrusion etc etc.