black03cummins
New member
- Joined
- Sep 21, 2010
- Messages
- 162
I have a set of rod bearings that were ordered in error for my build. The part number is CB-1873 AP-.25mm. Also, they were coated by PolyDyn. I only have 2 of the original boxes because I thought they were the right ones and when I found out they were not, it was to late to get the boxes.
These bearings have never been ran and I have only used them to check my clearances. I have never touched them with my bare hands, I always had gloves on. The reason these will not work for my build is becuase I am using machined forged rods out of an 01 and these bearings are for the cracked cap style rods. Also, these bearings are oversized. I would like to get 120.00 shipped.
Here is an explanation of what the bearing coating does.
5.9 Cummins PolyDyn coated pistons Part 4 - YouTube
I thought I should clarify alittle more. The way I used these bearings for my clearances is the top half of each bearings work as the top and bottom of what I need. I ordered a whole new set of bearings to replace these.
For reasurrance you can view my build.
My Little Build - Dodge Cummins Diesel Forum
These bearings have never been ran and I have only used them to check my clearances. I have never touched them with my bare hands, I always had gloves on. The reason these will not work for my build is becuase I am using machined forged rods out of an 01 and these bearings are for the cracked cap style rods. Also, these bearings are oversized. I would like to get 120.00 shipped.
Here is an explanation of what the bearing coating does.
5.9 Cummins PolyDyn coated pistons Part 4 - YouTube
I thought I should clarify alittle more. The way I used these bearings for my clearances is the top half of each bearings work as the top and bottom of what I need. I ordered a whole new set of bearings to replace these.
For reasurrance you can view my build.
My Little Build - Dodge Cummins Diesel Forum
