Mopar alluminum drive shaft NEW! For G-56 trucks

[lightsOUT]

I just picked this up today from the dealership. Apparently I ordered the wrong part number as it's about 2 inches too long. The dealer wants to charge me a $100 restocking fee so I'm just going to try and sell it on here. It's brand new in the Mopar box.

I prefer local pick up. I would ship it but it would probably be a small fortune.

I believe the problem I ran in to was that I have the Borg Warner transfer case which appears to be a little longer than the old NP transfer cases. They switched from NP to BW transfer cases sometime in 2012.

I believe this would fit any G-56 equipped 4wd quad cab long bed trucks from 2005.5 through 2009 or any mega cab short bed G-56 4wd trucks from 2006-2012.

Note: if it's a 2012 make sure it has a NP transfer case. Any body interested should check the part number for figment on their trucks to be sure.

Drive shaft comes equipped with front slip yoke, rear yoke and u-joints already installed. It's plug and play.

$700 picked up

Call or text 6109727415

 

[f6jbob]

Why not shorten this one 2"?:Cheer:

 

[lightsOUT]

I thought about that but with the added cost I would just rather sell this one and get the money back and just order the correct part.

 

[lightsOUT]

Bump.....

 

[lightsOUT]

TTT.... Make offer guys. Since I still have the box I could ship it easy enough but the shipping would be salty I would guess. If interested ill work with you a little.

 

[07srt6]

If it was for a auto I'd buy it, free bump for ya

 

[lightsOUT]

Thank. Measure the center of the front u-joint to the center of the rear u-joint on your truck. If I remember right this shaft is 77" center to center.

 

[Dieselmafialb7]

I'll go measure mine tomorrow see what my mega cab is. if it work for mine that'd be sweet

 

[lightsOUT]

Update: I just measured the driveshaft. It's 79.5 inches from the center of the rear u-joint to the center of the front u-joint.

 

[lightsOUT]

No longer for sale. Mods can move and close. Thank you.