Need help asap on fuel pressure!!!

C

ClayKann101

Zombie Hunter
Joined
Apr 27, 2009
Messages
971
I hooked up my Raptor 150 everything was fine until i started redoing my gauges. I found a fuel leak from the petcock on the fuel canister. It was just a drip but now its a flow i asked my buddy if i could rob the part off of his old dodge he said yes. So i put the different petcock on turned the key and to my surprise it held no leaks until about 5 more seconds then it began to spew everywhere. So i thought to myself i guess im running way to much pressure from the raptor. So i turned it down and it still leaked but not as bad. But now the truck wont start because i guess its lacking fuel pressure, so i turned it back up and it fires right up but leaks like a mofo. So i ordered a new petcock and orings but im afraid to put it on there without knowning how much pressure the raptor is putting out. Does anyone know how i can fix this? Are the raptors pre set from the factory?
 
BgBlDodge said:
Make sure you have the lines running to the correct spots.
Click to expand...

Everything is correct the truck runs great and right after i got it hooked up it didnt leak anywhere. I order the new petcock and orings but im afraid it may not work. Do you think im running to much pressure to it?
 
Most likely just a bad o-ring. Mine stuck in the open position one day. That sucked.
 
this happened to mine one day just out of the blue.. replace the o-rings and you should be good to go
 
You must log in or register to reply here.
Back
Top