need help wiring bd blow off valve

[bigorange]

ok I have a bd blow off valve and it didn't come with any paper work on how to wire it, I have a nv5600 tranny and found some stuff on how to do it on another forum but it says I need a micro switch to go to the gas pedle and my kit did not come with a micro switch so what the deal I some one could walk me threw the wiring that would be great thanks, shane :Cheer:

 

[onetun]

The micro switch is connected the the tps near the peddle. If you have no micro then there is no way to send a signal to the soliniod that activates the valve.
Rob

 

[devon lock]

If yours is a 05 it should have the TGE module and you wire it into the APPS sensor on the throttle pedal, for a 05 it should be a Brown w/ white tracer wire. This wire should range from .5-1volt at idle and 3-5 volts at full throttle.

The violet wire goes to The TGE module input and connect to APPS signal.
The gray wire goes to the TGE moduale output and connects to the spool valve.

There is also the full manual on BD web site.

I have one on my 03 6spd and it works good.

 

[bigorange]

just so i'm clear were about will I find the apps sensor close to the top of the throttle pedal ? thanks shane

 

[devon lock]

just so i'm clear were about will I find the apps sensor close to the top of the throttle pedal ? thanks shane

I don't know for sure mine is under the hood, the instructions just say for 04 and up it is on the throttle pedal