Need Installation instructions for JVD Torque Enhancer

[Limited]

I need to know how to hook this thing up. Its got 3 wires, black, red and yellow. I called Haisley and they e-mailed me instructions but my computer wont open it:doh: I want to put it on today or tomorrow but Haisley is closed now so any help is greatly appreciated!

 

[Limited]

Anyone? I called Haisley like 6 times today but there always busy

 

[BgBlDodge]

Sent ya a PM.

 

[Limited]

Thank you, I sent both to ya

 

[BgBlDodge]

Check your email.

 

[TravisG]

Limited- I went out and looked at the truck. I have a pump cover on the truck so I can't remember what wire to tap so you are on your own there. The red wire is to a 12v keyed source the black is ground and the yellow is the wire that you tap. Let us know how it turns out.

Which series of JVD box do you have? Look at the serial number and there should be a letter at the end, that is which series it is.

BigBlDodge could you e-mail me those instructions too. Would be nice to have on hand if I ever sell it.

 

[Limited]

S/n
2216feb

 

[Limited]

Thanks a lot BgBlDodge!!!

Anyway....hard to imagine with these directions and no pics, but assuming Travis is correct, then I just need a power and ground, then the yellow wire is the pump wire tap, looks like the same wire on the pump as the other boxes...so that would be super easy, wont bother to ground it like they say, any ground would work, right? Well I'll play with it tomorrow at work when I'm bored!:rockwoot::rockwoot: Let yall know how she works:Cheer:

 

[BgBlDodge]

It is the same wire on the pump that all the other boxes use.

I'm trying to get the pictures saved to my hard drive but they aren't working the way I want. Since they are embedded into a word document I can't just click on them and save them to my hard drive.

Travis G, pm me your email address and I'll shoot ya the instructions.

 

[Limited]

Got it all wired up, and it works, kinda. When you start to accelerate, the light comes on and gets brighter, just like it should, and you can tell there is more power. But then after the rpms shoot it, somewhere around 2500, the light goes off and no more extra power. Does this every time at around the same rpm, on either setting on the box, execpt off. Does this with the smarty on any setting and without the smarty. So what gives, bad box? Weak VP44? Now i'm worried...My connections are good and secure, the power wire is tapped into the right fuse, so I'm thinking it might be a bad box. The other thing is when you first turn the key on, before you start it, the light is supposed to flash a few times, but it doesn't.

 

[Limited]

Hey any yall still got the installation instructions? I can't find em..

 

[TravisG]

Send me your e-mail and I will look around and see if I still have them and shoot them on over.