No bus issue

[ryan.g]

I just finished putting the motor back into my truck. However, I cannot get it to start. When turned on I get a no bus? I've done a good bit of searching and know that grounds, ECM power and things like that can cause the issue. My question is, what sensors would cause the truck to not start? I plugged the holes for the MAP and IAT sensor as I mislocated mine. I plan on replacing them after I see if the motor will start. However, I'm not getting anything when trying to crank.

Any help is appreciated!

 

[ryan.g]

Also, Can you shrink the harness for a P Pumped 24V? My wiring is a disaster.

 

[Turbonetics TQ]

I have one that might be available in a couple weeks. - 20 wires I think.
Check the small ground on the passenger battery.

 

[ryan.g]

Thank you, I actually forgot all about that ground. Got it hooked up and it's perfect!

20 wires would be great. Mine looks terrible. When I moved the ecm back, it's hard to find things to do with all the unused plugs...

 

[Turbonetics TQ]

I will try and get some pictures up this weekend.

 

[ryan.g]

Thanks alot.

Sent from my DROIDX using Tapatalk

 

[Turbonetics TQ]

Here is some pics of the harness I made. I have a list of the wires I removed....somewhere.
There is a special tool to remove the pins as well as little white plugs for the unused holes (they look like LIFE game pieces). I have some of the part numbers for the stuff at work (CAT numbers)

 

[ryan.g]

Looks great man! Thanks for the pictures. Made your harness a 100x better.