Overflow valve thread size?

[Blackbumper]

I'm in the process of rigging up a pressure regulator to replace the overflow valve and the regulator has 1/4 pipe thread the overflow valve looks like 1/4 but it is not tappered like a pipe thread. It will screw in but feels a little loose due to the tapper. Any ideas?

 

[Ridemywideglide]

Wish I could tell you what size, but I can't.. BUT it's not pipe thread.
Take the OFV to the hardware store and match it.
Or take the guts out of it and just use it. No spring and ball, it's just a banjo bolt.

 

[Jim Fulmer]

Here is the P-Pump lay out!

Fuel Inlets or Overflow, there are 4........M14 x 1.5 pitch

Helicoil Removed.................................M16 x 1.5 pitch

Inlet above the rack cap......................M18 x 1.5 pitch

Jim

 

[Blackbumper]

Here is the P-Pump lay out!

Fuel Inlets or Overflow, there are 4........M14 x 1.5 pitch

Helicoil Removed.................................M16 x 1.5 pitch

Inlet above the rack cap......................M18 x 1.5 pitch

Jim

Thanks Jim that is what I was looking for now does anyone happen to know where I could find a M14 male to 1/4 Pipe male 90 elbow? And where did you find those specs?

 

[Jim Fulmer]

http://64.202.180.37/files/metric.pdf

Metric Banjo's and fittings, Summit also has fittings in Metric.

Jim

 

[Blackbumper]

Thanks again!