parting out 98 24v

dsl kicks gas

dsl kicks gas

Runnin on Broke
Joined
Aug 13, 2007
Messages
546
ok im parting out my 24v, it has a little over 200k on it. this is the engine only!!!! i replaced the head gasket(not that it matters now) 400mi befor i pulled it, head was decked and checked for cracks. replaced oil pan gasket at 160kish bottom end was looked new. everything that says new was replaced in the last 6 months stuff with no price listed, i have to see what the "going price" is, make offers on all of it, but please no low ball offers.

Block non 53, i belive it is the lightning block, but could be wrong
Head with valve springs
Crank
Rocker assmb
valve bridge/crossover's
push rods
new valve cover gasket $10
valve cover painted red $75
gear housing
timing cover
tappets
injector hold downs $20
motor mounts $50
stock cam $150
cam gear
core vp-44-may work selling as core $350
pump gear
oil pump $40
water pump $20
.093 crossover tubes $75
new map/turbo and IAT sensors $50each or $75 as set
new water temp sensor $25
oil psi sensor $25
valley/tappet cover w/ good gasket/seal $40
45 hp cummins ecm for 98-00 5-6spds $250
fuel return lines $25
oil fill cap $20
crank
set of pistions, con rods, and wrist pins(sell as set or seperate ie set of pistons set of rods and set of pins, not 1 or 2 pistions lol)
new head bolts $60
new lift pump with braket $75
new exhaust manifold $80
new apps $250
oil cooler
filter housing
therm. housing
pan and oil pickup
cummins starter $60
allison bell housing with ring gear $100
12V cummins manifold $20
fan bearing hub w pully $50
grid heater delete spacer $50
holset air compressor goes in place of ps pump would be nice for off road use $50 will also work on any cummins engine
24v intake horn $75
1st gen style intake horn $20
stock 24v injector lines
Edge Comp box $350
fuel filter housing $40
were harness $100

if there is anything i have left out....just ask injectors and turbo are already sold
 
how much for the head all hardware for the head and the cam gear
 
well ive got it all apart now......i belive the numbers on the pistons are 3807, but dont hold me to it. ill check in the morning to make sure.
 
tubes are already sold
done some tradin and now have a good 53 block with 180k with no problems ill let go cheap
ecm sold
luk clutch sold

i need this stuff gone and out of my way and the $$ to put in my 12v
i need
12v studs
p pump linkage
and a stock 35.....somebody wants to do some tradin let me know.
 
400 for the head, i paid 150 to have it decked and so on a week befor i pulled the engine, comes with stock springs and valves...all guides good


i dunno to heavy to ship, would have to be freight. ill check my zip is 47102

vp-44 sold
cross over tubes-sold
clutch-sold
ecm-sold
ex manifold-sold

make offer the only thing im set on the price is the block and head
 
looking4smoke

do u still have head bolts,oil psi sensor,and water temp sensor???and how much??
 
You must log in or register to reply here.
Back
Top