PDI 24v Manifold. T4 Flange

[BGarofalo]

This manifold is like new. Fits a 24v. Can be used for large single or twin setup on a CR too. It is a T4 flange so it WILL NOT fit most of the S300 turbos on the market. $400 takes it

 

[fnschlaud4620]

Dang! why couldn't have this been for a 12v, I was so ready to snatch it! How did you like the PDI manifold? I am planning on getting a T4 12v from them.

 

[BGarofalo]

Dang! why couldn't have this been for a 12v, I was so ready to snatch it! How did you like the PDI manifold? I am planning on getting a T4 12v from them.

It is a nice unit. Comes with a high temp coating. I have used many differant manifolds and the PDI manifolds seem to be one of the better castings.

 

[97' CTD]

I Call DIBBBBS. PM Sent
Brandon

 

[BGarofalo]

Here is the picture as requested.

 

[97' CTD]

I back out, I need to pay for motor 1st then I worry about this stuff...:bang
Brandon

 

[Ilikebikes]

I also wish it was for a 12V...

 

[TopFueler]

We should have them in stock! II

 

[BGarofalo]

Bump...

 

[tank21pa]

Is There Any Cracks?
Also How Firm Are You On It?

Thanks Matt

 

[tank21pa]

did you sell it?

 

[BGarofalo]

Sold

 

[Scooter's Roofing]

for future reference, you can port a 24v manifold to fit a 12v very easily