Piston Selection

0

01Grizzly

New member
Joined
Mar 18, 2009
Messages
136
Well long story short I had some valve to piston contact and I am in the market for a new set of pistons. My original plan was to mill/fly cut my pistons, but after speaking to the guys at Hamilton Cams and ordering my parts, they suggested replacing the pistons. I have looked around and see alot of people use Mahle or a standard Cummins piston. With my application I am unsure which route to go. The truck is a race truck with little to no street driving. 2001 P-pump pushing roughly 675 hp. Any input or advice would be greatly appreciated.

Thanks,
Kyle
 
Budget in mind? Fuel spray angle? A lot of information goes into this piston setup... Mahle makes a good one... The wisco piston setup I think was developed by smokem on here which is industry leader in my eyes
 
You must log in or register to reply here.
Top