Polished rebuilt s360

[AHall]

S300 with 60mm compressor inducer. Has extended tip compressor design. Non wastgated exhaust housing. Tore down, cleaned, polished and rebuilt. It has a t4 exhaust inlet and hx40 style outlet(allowing 4" downpipe). Has no thrust play and a little side to side play. But is in the middle of spec and after the bearings have oil on them it will be even less. Turbo has no damage.

Great top turbo for twins or with external wastegate use. Will spool faster than s362 so its great for towing, supports higher power than stock or hx35/40, and with the more durable design of borg warner. Shipping is from 80227 in lakewood CO. $750obo pm for offers or questions.

 

[Scooter's Roofing]

what size turbine housing? did you put new bearings and seals in it?

 

[AHall]

not sure the housing size. it doesn't have any markings i could see as far as cm. yes new bearings orings seals.

 

[Scooter's Roofing]

schwitzer/BW turbos don't use cm measurements... there should be an A/R number inside the inlet of the turbine housing

 

[AHall]

0.91a/r

 

[48snowman48]

What does a .91 compare to?

 

[zstroken]

Probably a 16 or 17.

 

[AHall]

on this size of turbo id say it would be smaller than 16 or 17 but i could be wrong. just doesnt look that big to me

 

[kscummins]

what kinda HP will it support? my 35/40 is maxed and I wanna run 5*12 or 5*14 injectors.

 

[Delinquent]

Id say it is good to 450...

 

[AHall]

Id say 450hp or a hot 500hp

 

[pitkrew]

Is the turbo still avail?

 

[AHall]

it is still available

 

[Scooter's Roofing]

T3 or T4 housing?

 

[okish]

He said t4

 

[AHall]

Bump.....

 

[BigErk77]

I dont see a wastegate... is it wastegated?

 

[Gibson]

It's non gated homie

 

[Scooter's Roofing]

honestly, it looks like it might be a 62/68