Primary mount bolt size?

[smokin247]

Looking for the size of the threaded holes on the motor mount to bolt a source style primary mount to? Any help would be great thanks

 

[bsmith]

Looking for the size of the threaded holes on the motor mount to bolt a source style primary mount to? Any help would be great thanks

M10 or m8x 1.5. Call source they'll tell you. I've did it many times.

 

[smokin247]

M10 or m8x 1.5. Call source they'll tell you. I've did it many times.

Thanks I'll try the m8 1.5 the other holes on the bell housing were m8 1.25 and those did just look like a finer thread.

 

[Tate]

M8x1.25 is the coarse metric thread.

 

[smokin247]

I meant I would try a m8x1 the 1.50 I was thinking higher thread count when I looked at it this morning but were talkin metric

 

[smokin247]

It's smaller than 8m but just barely it must be fine thread standard. I'm goin to try calling source

 

[bsmith]

It's smaller than 8m but just barely it must be fine thread standard. I'm goin to try calling source

Yeah just call them, they might still be open.

 

[smokin247]

Sorry everyone I'm an a$$ hole they are m8x1.25. Mine were just so corroded you had to force them in a few times until they started to thread right.

 

[Tate]

Thats what taps are for. Clean the threads before putting the bolts in them.

 

[smokin247]

Thats what taps are for. Clean the threads before putting the bolts in them.

True and I will before it is installed but I was trying to get all the bolts together before I left for the weekend. To be honest I don't have taps on hand, and i had to put a lot of money into wiring and setting up the garage I'm using to make it some what workable. So now almost all my money is going into parts orders.
Thanks for the help guys