Project pullin motor...

[parttimepuller]

I would like to hear some opinons on different parts that people run.. Was it worth the money???

Motor will be a full time puller... Probalby a 2.6 motor maybe a 2.8...

Like to know things:

adjustable pump gear

GEar drive lift pump or FASS/AD

Billit Cam or Cast big regrind..

P/P head with cut off intake???

 

[97' CTD]

Big cast regrind. :rockwoot:.
Brandon

 

[parttimepuller]

Big cast regrind. :rockwoot:.
Brandon

Yeah I think so too. My block is good so it doesnt need to go to the shop for work....

Did you use factory dampener or aftermarket???

 

[lenahan05]

adjustable gear would be nice but not needed. also the gear driven pump is nice but for those classes it's a waste of money. as for the cam i'd go with a cast regrind. especially if you get your head ported and done right you won't need a giant billet cam to make good power up top for pulling in the 2.6 or2.8 classes. if your on a somewhat limited budget i'd go with the ported head and intake with a 24v cast cam regrind. but that's just me.

 

[parttimepuller]

Where's a reasonable place to do P&P???