Rolling on dubs...

[mathews8pt]

I like it, but i think it will look even better lowered a little.

I went with 2" blocks in place of the factory rear blocks and cut 1/2 a coil out of the front. If you dont want to cut the front down i would go with a 2.5-3" block in the rear instead of the factory 4 3/4" block.

 

[FordGuy24]

Looks good!

 

[SuperDave4x4]

I like it, but i think it will look even better lowered a little.

I went with 2" blocks in place of the factory rear blocks and cut 1/2 a coil out of the front. If you dont want to cut the front down i would go with a 2.5-3" block in the rear instead of the factory 4 3/4" block.

The plan is to lower it. I wont lower it any further than just the factory front spring. If I do that then I will level the rear to match.

When I get back to the house I'll measure the tops of the fenderwells to see how much higher the back is compared to the front.




Thanks FordGuy!

 

[DieselAddict1on]

I like the tow hooks and the roll pan

 

[scarface]

is that a 6 or 7 inch stack?

 

[SuperDave4x4]

6"... Go with 7" if you trying to decide....

 

[diesel_importer]

I like it! I've gotta get my truck detailed, and all the tar off my rear quarter panel. Your's looks clean as hell!