S300/S400 twins, DDP 4s

J

justblownsmoke

New member
Joined
May 18, 2008
Messages
29
Custom built compound turbos for a 12 valve 2nd gen. This set comes complete from air filter to oil drains and is ready to run. The top turbo is a Quick Diesel 64 (64/71/14) built by High Tech Turbo with approximately 6000 miles. The bottom turbo is a S400 with a 75mm compressor and a 96mm turbine with the 1.32AR exhaust housing. The S400 has about 18000 miles on it. This setup was good for 80+ pounds of boost while maintaining a drive pressure ratio of 1:1. All the cold pipes have been recently powdercoated and the hotpipe and downpipe are heat wrapped. Works on a stock exhaust manifold as well as a three piece with minor modifications. Asking $3250.

I also have a set of DDP 4s that have the the edge filters removed and i added .015 of pintle lift and set pops at 280 bar. $550
 

Attachments

  • IMG_4990.jpg-resize.jpg
    IMG_4990.jpg-resize.jpg
    117.1 KB · Views: 215
  • IMG_4992.jpg resize.jpg
    IMG_4992.jpg resize.jpg
    115.9 KB · Views: 207
  • IMG_4996.jpg-resize.jpg
    IMG_4996.jpg-resize.jpg
    113.1 KB · Views: 174
I had to trim out a little bit of the gusset that sits behind the foot because the hotpipe would hit.

Payment pending on the injectors
 
A new bottom turbo mount and a new intercooler pipe for sure and you might have to move the battery or rework the air filter to go to the front corner instead of back.
 
up for any trades? I got a STS turbo kit for a chevy silverado v8 gasser with upgraded turbo and intercooler?
 
You must log in or register to reply here.
Back
Top