s300 tolerances

[Knuckledragger]

i got a new 64/14 s300 and i was boltin it up. out of habbit i happened to grab both ends of the shaft a move it around. it felt to me to be a little excessive movement. there is about 3-4 thousandths end to end and about .036 moving the compressor wheel side to side. what are the tolerances on this turbo? im hoping i dont have an expensive boat anchor. thanks for any input.:bang:bang

 

[SilverBack76]

If your talking in and out movement there should be none.

 

[Rollin Coal]

.0005 in and out and .020 up and down dry are the specs if i remember right

.003 in and out def needs a rebuild

 

[GOLDDUSTERS5703]

If your talking in and out movement there should be none.

x2..............