s400 oil suppy line??

04DEEZELRAM

04DEEZELRAM

Offshore operations
Joined
Nov 25, 2007
Messages
416
Ok guys im looking for what i need to use to get my stock oil supply line to hook up a s465 on my 04 dodge.....does anybody know what fitting i need to make it work...or any other ideas???...Thanks
 
The S465 is a 1/4"NPT inlet so just take your old line to a hydraulic shop and get a new one made.
 
oil line

i have a machined 2 bolt flanged for the center section and the an line and fitting for the top of the oil cooler if you want. i made two of them one in a -4an and the other in a -6an braided s.s. i've test fitted both of them and fit fine.
 
The fitting I got from the local industrial supply was 1/4" pipe thread to whatever the stock line is and cost me less than 2 bucks... I would go that route, just take your line in and let them match it up.
 
Mine just unscrewed off my S300 and then screwed right in the new S400 off my '06 whats the difference?
 
JFlagg said:
The fitting I got from the local industrial supply was 1/4" pipe thread to whatever the stock line is and cost me less than 2 bucks... I would go that route, just take your line in and let them match it up.
Click to expand...

Ill probaly try that first, and if not ill get a new line made
 
oil supply

i used a flange fitting like this on the feed and the return. on the return i made a new adapter to go into the block like the second pic.
 

Attachments

oil line

yes,
it uses the oem o-ring so you can get at any dealer if it goes bad but i've never seen it go bad. i put the ring on it so i could tap it into the block.
 
You must log in or register to reply here.
Back
Top