S475/96/1.10 T6 and HX82 4.1"

syrupdawg

syrupdawg

GA Diesel Mafia
Joined
Mar 16, 2008
Messages
1,792
These are the turbos that I was going to run on my race truck but Im going to down size some and put a smaller set on my SRT truck.
Engineered Diesel built the chargers
Billet S475/96/1.10 with a T6 that has the exhaust flange machined to hx40 to go to 3.5" pipe for the hot pipe.
HX82 is 4.1" with a G-Trim turbine wheel. It is a monster. The outlet has a vband welded on. The turbine housing is a 36cm.

$5000 for the pair
 
Forgot to mention both of these are brand new never been ran.

Also the inlet on the s475 is banded for 3.5" piping. I'll post pictures as soon as they upload
 
Last edited:
IMG_20140814_093747_145_zpse3zrfly4.jpg


S475 inlet VBand
IMG_20140814_093758_648_zpsfp0lpo41.jpg


A little knick on the HX82 downpipe flange. UPS did it in shipping from ED I guess but I don't think it will mess with the flange sealing.
IMG_20140814_093833_200_zpszyh7myt7.jpg


Compressor inducer on the HX82
IMG_20140814_093650_676_zpstinrtpe4.jpg
 
Sorry didn't see where this was updated. The hx82 is gone. I would like to get $2000 for the s475. Billet wheel, vbanded compressor inlet, and a t6 1.10 a/r turbine housing that is machined for a hx40 outlet. It is a perfect high horsepower secondary charger
 
What did the hx82 sell for if u don't mind me asking been looking for a 4.1 and can't hardly find one.
 
You must log in or register to reply here.
Back
Top