Some random 24V stuff...

JFlagg

JFlagg

Gun for Hire
Joined
Jul 27, 2007
Messages
5,630
I have some random stuff for sale that been accumulating in my garage during my truck rebuild. They are...
1.Full set of 24v connecting rods, all in great shape, just came back from the machine shop. Not balanced or weighed, but checked non the less. Make offer, not sure what they are worth.
2.Full set of stock 24V valve springs. Off stock truck, so never seen more than 34-3500 rpms. No keepers or retainers. Make offer.
3.Nearly new TPS off manual tranny truck. About a year old with less than 5K on it...Make offer
4.Afe air filter, make offer.
5.stock Cummins pistons, 3 actually... their dirty and oily since they came out of the motor. Looks like slight scuffing on the skirts but I don't need 'em. Whoever wants to make an offer, they're yours.
6.stock fuel filter housing. Came off after Fass install. Make offer
7. Two 24V timing gear housings...One is clean the other alittle oily, but I'll clean it before I ship it. Make offer.

I'm sure I'm forgetting some stuff...basically make me a reasonable off on any of this stuff. I need to clean out my garage since its starting to look like a Cummins parts dept. LOL Buyer pays shipping on everything.
 
Also have 4 chrome trim rings for the OEM steel wheels. Once again, make me an offer :D

Payment pending on the fuel filter housing.
 
I also have a set of twins, minus any plumbing, I would sell also. HTT 60mm HX40 w/ 14cm ex. over a HT60. I think the 60 has a 26cm ex. housing... The 60 is also a 2.9 inducer. Both are in great shape and would make a great set of towing twins. Should be good for around 600 hp I would think. I'd like $1000 up shipping for both. Might seperate if I can find sellers for both
 
Found a Cummins crank also out of a 2000 sitting in my garage too... :D
 
Payment pending on 3 spare pistons, one 24V timing gear housing and fuel filter housing is sold! Also found a spare stock 24V exhaust manifold... has one small crack starting near the flange. Would make a good mock-up manifold. Make offer
 
24vriviera said:
u have a spare oil pan? i got 20 plus shipping
Click to expand...

That is one of the few things that wasn't any good on the spare motor I was able to scavenge, the front axle got jammed up to it and it was smashed. Sorry.

And Roachie, consider the rods and wrist pins yours. PM me what you think they are worth to ya. I tihknI can ship them for $40, but they will be heavy :D
 
I have two sets of tappets also I found, look to have no wear at all... about 100K on both sets. make and offer. Still have the HT60 I would like to sell or trade... let me know what you have.
 
You must log in or register to reply here.
Back
Top