Super B Special, S&B intake, airdog 150

[20valve]

All of these came off my '01 24 valve *Will have pics up this weekend*

BD Super B Special
Downpipe, clamps and any hardware that came with it. About 6k miles on it, too laggy with an untapped quadzilla. $1200 OBO

S&B Intake
Filter needs to be cleaned and re-oiled. All hardware with it. $150.

Airdog 150
Took it off my other truck in June, been sitting since. I ordered new lines, fittings, fuel filler return pipe and a pickup. I have the wire harness and whatever was attached to it as well. May have new Baldwin filters to go with it as well, but I'll have to check part numbers. Pump was replaced about 2 years ago under warranty. Frame mount has some peeling paint. Small things like zip ties, instruction book and the o-ring washers are missing. $350.

Not sure if I have to make a new post, but I need the following:

Stock HX35 turbo in good shape
Stock intake box and elbow (turbo-to-intake accordion dealy)
Willing to work on the above prices if you have these for partial trade.

 

[fahtb0y]

How much for the turbo.

 

[20valve]

Just the turbo with no downpipe or hardware I assume?

 

[40ray]

Would you be interested in a 63/68/14 or a 62/65/14 both would spool better than the super b special.

 

[40ray]

Also have a stock turbo and intake how much do you value that in a trade.

 

[20valve]

I just bought one yesterday off of a member here. Sorry about that.

 

[20valve]

All of these came off my '01 24 valve *Will have pics up this weekend*

BD Super B Special
Downpipe, clamps and any hardware that came with it. About 6k miles on it, too laggy with an untapped quadzilla. $1200 OBO

S&B Intake
Filter needs to be cleaned and re-oiled. All hardware with it. $150.

Airdog 150
Took it off my other truck in June, been sitting since. I ordered new lines, fittings, fuel filler return pipe and a pickup. I have the wire harness and whatever was attached to it as well. May have new Baldwin filters to go with it as well, but I'll have to check part numbers. Pump was replaced about 2 years ago under warranty. Frame mount has some peeling paint. Small things like zip ties, instruction book and the o-ring washers are missing. $350.

I can't figure out how to edit on mobile, but here's the updated ad. Found the stock parts, so I'm looking to sell only right now.

 

[20valve]

Updated with pics

S&B Intake. The last pic shows some wear to the boot from the intake tube to the housing adapter. It's just in this area, but doesn't go all the way to the inside of the pipe. In other words, no air leaks.

 

[20valve]

Airdog 150 pics

I believe one adapter is missing. The fittings, washers and fuel lines are all new, never installed. However, I count 5 connection points, but 6 are needed. I think it may be one of the ones of the fuel pump, but the existing fittings on the pump itself may work. That I'm not sure of and its something the buyer may need to check on. Filters were kept on to protect the fittings and ports, around 3000 miles on both (will be taken off prior to shipment).

 

[20valve]

Super B Special pics

Downpipe, downpipe clamp, turbo and possibly the adapter fitting come with it. I can't remember if the stock HX35/HY35 can be used with this or if it's specific to the special, but my stock turbo has one on it so I'll include it with this one. Minimal shaft play side-to-side, about what I remember from it being new. 6000 miles or so, wastegate is set to 40psi, but my setup will only fuel to 23 psi or so. Compressor wheel did not touch the housing as is seen in the pics.

 

[20valve]

The intake and airdog are off the truck, the turbo should be off this week pending arrival of my downpipe for the stock one.