FlyingHighRacin
New member
- Joined
- Nov 12, 2008
- Messages
- 445
Ok so I sent my pump out to TC Diesel to have it rebuilt and modded more. I also ended up getting one of their wild rails and a cprv set at 27000psi.
Anyways just got it all installed tonight and fired the truck up and CEL is on and stays on and I'm throwing 2 codes
P0193- fuel rail pressure sensor voltage too high
P0236- map sensor to high too long
I'm not getting any reading from my RP gauge either and the truck in idle just doesn't sound right. Its not an irratic idle or a knocking sound. Just doesn't sound like what it did before I pulled the pump off.
I didn't get a chance to call Todd to see what he thinks is the issue but I'm gonna call tomorrow. Just wanted to see if anyone would chime in and give me some advice or knows what the problem may be.
Sent from my SPH-M910 using Tapatalk
Anyways just got it all installed tonight and fired the truck up and CEL is on and stays on and I'm throwing 2 codes
P0193- fuel rail pressure sensor voltage too high
P0236- map sensor to high too long
I'm not getting any reading from my RP gauge either and the truck in idle just doesn't sound right. Its not an irratic idle or a knocking sound. Just doesn't sound like what it did before I pulled the pump off.
I didn't get a chance to call Todd to see what he thinks is the issue but I'm gonna call tomorrow. Just wanted to see if anyone would chime in and give me some advice or knows what the problem may be.
Sent from my SPH-M910 using Tapatalk
