timing advise

rpainter

New member
Joined
Feb 27, 2008
Messages
914
what are you guys running for timing in a strictly 3.0 puller? injectors are 6x.018 and .093 lines and tubes??
 
stock pistons? whats the spray pattern like on the injectors? most sticks the limit is about 27* degrees before you are out of the bowl.

best bet is to set it, then check on a timing light and adjust accordingly. i run 27 on mine and it seems to work well, no fuel in the oil, not a ton of haze, and good power. but this all depends on the pump, mods, lines, etc.
 
My buddy runs 38 in a 3.0 puller I think 6x20 ish INJ , ran up to 42 on the dyno but turnd it down some , made over 1000hp to
 
Top