Turbonetics Pulling Charger Mid-frame 3x3

[dodgediesel98]

I have for sale a turbonetics ceramic ball bearing pulling charger. used but in like new condition. the specs are as follows:

3in. inducer
3in. exducer
76mm front wheel with custom ported 3.0 front cover
81mm exhaust wheel with 1.27 a/r housing
Exhaust housing is a t4 flange with a 4.5in. down pipe connection

has ceramic ball bearings and zero shaft play, i have almost $3,000 in this charger with the custom front cover and garrett front wheel.
Asking $2,300

 

[cboycadi]

bump

 

[extreme_cummins]

could this be run as a single on a 3rd gen. also whats the cfm or hp it will support?

 

[dodgediesel98]

yes it is possible to run this as a single on a third gen. with the right amount of fuel and tuning. I would say that this charger is capable of supporting 1000hp as a single. It still has almost 6 months left on the turbonetics famous 1 year ,no questions asked, can't bust it warranty and i only had it on for 3 hooks, so it is still basically new.

 

[rawdog]

why are you going to get rid of it?

 

[dodgediesel98]

changed my set-up and i needed a charger bigger than a 3.0, so this one has got to go. it has been my kitchen table center piece for the last 3 months and i am tired of looking at it. :charger:

 

[bigpapared]

bump

 

[cboycadi]

bump

 

[cboycadi]

bump droping the price to 2000 obo

 

[cboycadi]

BUMP cmon guys need to get rid of

 

[cboycadi]

bump anybody give offer

 

[dodgediesel98]

ttt anyone drop price to 2000.00

 

[dodgediesel98]

Bump still got it need to sell make offer

 

[cboycadi]

bump

 

[SMOKIN93]

what's the smallest ex housing you could get for it?

 

[dodgediesel98]

smallest exhaust housing made for it is a .90 A/R

 

[dodgediesel98]

bump

 

[Farmboypuller97]

1500 and i pay shipping what ya think?

 

[joelc79]

That would be a badazz center piece for a kitchen table.

 

[dodgediesel98]

ttt