Turbonetics Y2K HP-88 bottom turbo

[Eastern Diesel]

I found a good deal on a (Turbonetics Y2K-88MM E-Trim Ball Bearing Turbo .http://www.turboneticsinc.com/products/index.php?products_id=922&category_id=8096 T6) and was wondering how it will work for a bottom and what size top turbo would I need?

 

[Jim Fulmer]

Shame, I had one on here a few months ago with no one interested, it sold on E-bay for $1500 and was just short of new.......I mean like 50 miles or less with a fresh tear down/look over.

Do you wna the Map for it? 120 lb/min at 3.7 P/R

Jim

 

[Eastern Diesel]

so what would pair up good with it?

 

[B18B1LS1]

A 66mm would go nicely. Thats alot of turbo, what are your goals, near 1000 rwhp?

 

[Jim Fulmer]

Oh that's only 1880 cfm from just the bottom turbo! It should run good up to about 50 psi by itself.

Match that with a 66 and you have a heck of a combo that would still spool good.

Jim

 

[Eastern Diesel]

Ya I would like to end up with 1000hp but it will be down the road I found this turbo so I figured I would get it and then work on building the twins and a new motor as funds allow.