okay I have figured out how to afford the setup now. question is what would u recommend setting the waste gate on the psi at on the secondary? And how would I know if I have an updated htt turbo that has the wastegate fix. I have only had this turbo for three months. Any advice on this twin setup will be appreciated. thanks dave
twin install ? 62/71/13ss &s475
- Thread starter tirefrier
- Start date
tony597fitter
Tax Payer
- Joined
- Dec 3, 2006
- Messages
- 2,125
Call HTT. Or look up the wastegate thread on here started by Jason Czerak, it shows the new arm and puck setup.
HTT wastegate TEMPORARY FIX, while waiting for the real - Competition Diesel.Com - Bringing The BEST Together
You need to set the secondary for around 35-40 psi, that will then put you double with the primary 70-80psi, if you have the fueling for it.
I'm doing a E.D. 62/68/14 with a S475 that I'm sending out to E.D. for some massage work.
HTT wastegate TEMPORARY FIX, while waiting for the real - Competition Diesel.Com - Bringing The BEST Together
You need to set the secondary for around 35-40 psi, that will then put you double with the primary 70-80psi, if you have the fueling for it.
I'm doing a E.D. 62/68/14 with a S475 that I'm sending out to E.D. for some massage work.
Muddin_dude06
...
- Joined
- Sep 10, 2007
- Messages
- 2,541
35-40? I always thought you set the secondary at around 17-25 that way it starts really feeding the primary sooner to help get it up to full tilt quiker? I am probably wrong, I haven't had twins ever. But I dream of havin' a set sooner than later...
Tony, I want to see how you like that ED 62mm. I bet that thing will be sick!
Tony, I want to see how you like that ED 62mm. I bet that thing will be sick!
tony597fitter
Tax Payer
- Joined
- Dec 3, 2006
- Messages
- 2,125
I hope so.
I'm doing a NV4500 to 47rh full billet Goerend trans conversion.
I hope to have it done next week with the new E.D. turbo on.
Will keep everyone posted.
As far as the twins, I'm still learning so I'm probably wrong.:bang
HIGH TECH RAM
Haters!
- Joined
- Jul 24, 2007
- Messages
- 2,857
Put a DP spring acuater on and just balance the seondary to the primary (2:1). If you want to adjust total boost then make sure pop offs are in place
HIGH TECH RAM
Haters!
- Joined
- Jul 24, 2007
- Messages
- 2,857
Just put a DP spring acuater on the secondary. Adjust it till you achieve a 2:1 between topand bottom. If you want to adjust total boost then make sure pop offs are in place.