jessmeistertc
Pro Driver
- Joined
- Nov 10, 2008
- Messages
- 370
Going back to a single. These Twins consist of a Holset H1C with a 60mm GDS compressor housing and wheel with your choice of 12cm or 16cm exhaust housing; 12 is on it now. over a Borg Warner BHT3B w/ 26cm housing. Both chargers are used, but have minimal shaft play. I added an E.D. 50mm external gate to this setup so I could run a tight exhaust housing on my secondary and was planning on putting nitrous on, but never did. The hotpipe, wastegate dump, and downpipe are all wrapped in black exhaust wrap. Includes turbos, wastegate, oil feed and drain lines, cold piping(cold use a fresh powdercoat), wastegate plumbing, intercooler pipe on passenger side and 5'' downpipe. Just figured it up. got a little over $3000 in this setup. Gonna need $2600 plus shipping. I will throw the 24V 3 piece BD exhaust manifold in for $150 extra if you need it. Will take $500 off if you dont want the external gate. Will take partial trade if you have a good HX35 or a 62-64mm charger. I live in Alexandria, IN if you want to come look at it. Thanks,
Jesse
Jesse
![1028091709a.jpg](http://i271.photobucket.com/albums/jj152/jessmeistertc/1028091709a.jpg)
![lokar.jpg](http://i271.photobucket.com/albums/jj152/jessmeistertc/lokar.jpg)
![1028091710.jpg](http://i271.photobucket.com/albums/jj152/jessmeistertc/1028091710.jpg)
![0819091528-1.jpg](http://i271.photobucket.com/albums/jj152/jessmeistertc/0819091528-1.jpg)
![0819091400-1.jpg](http://i271.photobucket.com/albums/jj152/jessmeistertc/0819091400-1.jpg)
![1028091709.jpg](http://i271.photobucket.com/albums/jj152/jessmeistertc/1028091709.jpg)
![1028091711.jpg](http://i271.photobucket.com/albums/jj152/jessmeistertc/1028091711.jpg)
![1028091712.jpg](http://i271.photobucket.com/albums/jj152/jessmeistertc/1028091712.jpg)